Instructions for Setting Up Outdoor Lights

Lighting up your outdoor spaces is a simple method to extend your time there. Decks, patios, water features, ponds, and pathways can all be improved with the help of outdoor lighting. Because it operates on 12 V of electricity, low-voltage lighting is safe for the do-it-yourselfer to install and is incredibly easy to set up.

You’ll need light fixtures, a transformer, and low-voltage electrical wiring to create an adequately lit pathway. The transformer must be connected to a weatherproof, outdoor GFCI outlet. This substantial plastic device covers the outlet and features a cutout for the cord to enter. The transformer allows us to change the potentially dangerous 120 V energy into a safe and usable 12 V system.

Verify the regions you want to illuminate and the desired impact before proceeding. We’re going to assume you’ve done your research, shopped around for your fixtures, and bought a transformer big enough to handle the whole electrical load of them. OK, now we can get started.

The initial step is to arrange the parts. Put the lights in a row along the path you’re lighting. Then, using the low-voltage cable, connect each morning to the transformer, weaving in and out of any potential impediments like trees and bushes. Keep the wires untied; we’ll be burying a short loop of cable around each light fixture. If the power requirement is less than 200 watts, use a 14-gauge wire, whereas if it’s more than 200 watts, use a 12-gauge cable. The minimum distance between the transformer and the first light is ten feet.

Next, you’ll want to dig a trench. To explore the ditch, use a spade with a flat blade. To accommodate the cords, it needs to be at least three inches deep.

Step three involves sinking the wire. The low-voltage cable of the proper gauge should be inserted into the newly dug ditch with some slack left in it. The wire must be inserted into a hole cut in the grass.

Fourth, holes must be drilled for the fittings. Be sure to position your lights properly so that their illumination is uniform around the room. Instead of a hammer, use stakes to plant the light fixtures in the ground firmly.

Wiring the lights is the fifth stage. Please refer to the brand-specific installation instructions included with your specific brand of fixtures. Most mornings, however, just require you to slip the connector at the base of each morning around the electrical line and snap it into place. The fast-connect component has successfully pierced the low-voltage cable and formed a secure connection.

You could also split the cable and use wire nuts to wire it like a standard light fixture if you wanted a more secure connection. If you go this route, ensure sure the cable nuts are waterproof by sealing them with silicone. After the lights have been wired, place each one firmly into the holes you dug and insert the stake that came with it. Make sure the stake is level with the grass and bury the connector and wire at least two inches.

The transformer’s sixth step is to be plugged in. To prepare an electrical cable for placement near a transformer, remove its insulation and peel out its wires. The transformer can be attached to the house or a pole. After the transformer has been mounted, the cables can be connected to the terminals at the bottom of the unit. After turning it on, the lights in the fixtures should come on if you have done everything correctly. If there are issues, before blaming the transformer, ensure the lights are correctly inserted and functioning. When the lighting has been checked and is working correctly, the grass should be tucked around the fixtures and pressed down firmly along the trench.

At long last, you get to reap the rewards of your efforts. With effort and planning, anyone can improve their home’s nighttime curb appeal with attractive, adequate landscape lighting. Very minimal upkeep is needed with low-voltage lights. Remember that the remaining bulbs will not last as long if you wait too long to replace the burned-out ones. Aside from that, you can relax and take pride in a job well done.

Derik provides advice for outdoor landscape lighting on his website [http://outdoorlightingauthority.com/outdoor-landscape-lighting/] and in his writings about various types of outdoor lighting [http://outdoorlightingauthority.com/].

Link to Original Article: http://EzineArticles.com/2906178

Read also: Instructions For Putting In A New Pool Liner